Depending on the planned installation direction, it should first be checked from which room side installation is due to begin so that difficult installation scenarios can be avoided. Subsequently, the room must be measured to determine whether the width of the first row of boards should be reduced. This will be necessary if the last row is calculated to be less than 5 cm wide. The method for installing the first or the first two rows depends on the click system in use. Follow the installation instructions.
In order to prepare the last row to be cut to size and installed, place the flooring elements to be built in at the planned position exactly on the row before the last. By means of a residual floor board (element width + edge joint width) it is possible to transfer the wall structures to the floor board within a pre-chosen distance. The adjusted / cut-to-size floor boards are then clicked into the row before last.